Replicating Electronic Circuit Board

Replicating Electronic Circuit Board Gerber file and restore schematic diagram from circuit board;

When Replicating Electronic circuit board, no matter what kind of PCB reverse engineering software you are about to use, each one of them will have the automatic copper clad functions which has played an important role technology. The necessity of copper clad process has several reasons:

The reason of copper clad on PCB board cloning is:

1, copper clad should connect with grounding line, which can effectively reduce the revert route area;

2, large area of copper clad equals to decrease the resistance value on the ground line;

No matter for digital ground, or analog ground, copper clad is required to increase the capability of resist the interference in the process of replicating circuit board, when in high frequency, the copper clad should be arranged separately by digital ground or analog ground, and then connect them by single point, this point can circulate the magnetic ring and then make connection. However if frequency of Electronic circuit board is not so high or if the working conditions of instruments is not very bad;

Crystal in the printed circuit board design can be used as a high frequency radiation source, design engineer can layout copper clad, and then connect the crystal enclosure to the ground will be better.

Tags: replicate circuit board,replicate circuit card,replicate pcb,replicate pcb assemble,replicate pcb board,replicate pcb card,replicate pcba,replicate printed circuit board,replicate printed wiring board,replicate pwb,replicate pwba