Printed Wiring Board Reverse Engineering

Printed Wiring Board Reverse Engineering means not only duplication but also include extract the embedded firmware from encrypted microcontroller, reverse engineering circuit board schematic diagram, compile the bill of material, as well as PCB board modification and re-layout, etc.

Schematic diagram is a drawing constituted by a series of electronic and electrical signals for analyzing the circuit principle. It plays an indispensible role in the process of printed wiring board debugging, repair and maintenance, modification.

Some customers who require PCB clone service will also request it. It is the inverse operation of electronic pcb card relayout in which schematic will come first follow by layout. However the schematic is acquired from extracted layout or GERBER, for the convenience of subsequent electronic product technical analysis and prototype debugging and upgrading.

Compile bill of material list:

In the process of PCB reverse engineering, BOM and each component’s orientation, SMD coordinate graphs are all necessary steps for incoming prototype soldering, SMT and complete prototype design and assemble. BOM is the basic datasheet of electronic component sourcing, it record all the necessary components, modules and other special parts. The most important thing is ensure all the parameters inside the BOM are all precise after get. Since any parameter mistake will affect the preciseness of sourcing work even cause the failure of whole project.

Tags: replicate circuit board,replicate circuit card,replicate pcb,replicate pcb assemble,replicate pcb board,replicate pcb card,replicate pcb circuit board,replicate pcba,replicate printed circuit board,replicate printed wiring board,replicate pwb,replicate pwba