Printed Circuit Board Cloning Cost

In order to certify the work quality of Printed Circuit Board Cloning, it needs to manufacture and assemble the Printed circuit board through the automatic surface mount technology, which can also be described as over flow soldering. Inside it there is solder flux mix with the soldering article, the Printed circuit board must be treated and before assemble them, after curing it need to treat it again. After the temperature of Printed circuit board cool off, it need to go through the final test.

in the process of PCB manufacturing process, engineers are always thinking of the way to optimize the manufacture procedures to low down its cost, however, one of the most important purpose of electronic PCB circuit card reverse engineering is figure out the way about how to minimize the size of Printed circuit board and make it more suitable for the principle of design for manufacture. In order to decrease the manufacturing cost of Printed circuit board, there are several factors can be taken into account:

1^st of all, the dimension of Printed circuit board is a important element, the smaller size it possess, the lower cost it will have during the Printed circuit board production after PCB card Cloning. Partial areas on the Printed circuit board have become standard ones as long as the standard can be followed properly the cost of manufacturing will decrease naturally. And on some international website you can find the information about standard dimension of Printed circuit board.

2^nd, use surface mount technology can save more money than use the through hole technology, since the density electronic components on the Printed circuit board could be larger with smaller size.

3^rd, if the density of electronic components on the Printed circuit board must be very dense, then the layout after Printed circuit board Cloning must be very dense too, and the tracks must be very thin too, and the price of facility which will be used Printed circuit board manufacturing could be very expensive. Furthermore, the material used for Printed circuit board fabrication should be with higher standard, and the printed circuit board cloned layout design must be extremely careful and prevent the generation of power consumption on the circuit design. The solutions of these issues can bring much more cost cutting than the reduction of Printed circuit board size.

Tags: pcb assemble cloning,pcb board cloning,pcb card cloning,pcb cloning,pcba cloning,printed circuit board cloning,printed wiring board cloning,pwb cloning,pwba cloning