PCB Microcontroller Firmware Reverse Engineering

PCB Microcontroller Firmware Reverse Engineering needs to study the function interface which has been used to completes the function, data structure, global variables, and the process of calling each function interface when completing the task. After the detailed design of the PCB Microcontroller Firmware is completed, it enters the specific coding stage.

Under the guidance of the detailed design of the PCB Microcontroller Firmware, the software coding of the entire system is completed. It must be noted that the PCB Microcontroller Firmware will enter the actual coding stage after the detailed printed circuit board documents are reverse engineered completed, and the hardware will enter the specific schematic and PCB implementation stage, so as to be as thorough as possible at the beginning of the PCB board layout redesign and avoid repeated modifications during the design process.

Improve development efficiency. Don’t start the actual design steps without completing the detailed design just for the sake of the drawing. Stage 6&7: Product commissioning and verification This stage is mainly to adjust the hardware or code, correct the existing problems and BUGs, so that it can run normally, and try to make the product functions meet the product requirements specification requirements.

Verify whether a single function of the software is realized, and verify whether the entire product function of the software is realized.