Cloning Printed Circuit Board File Summary
Cloning Printed Circuit Board File which can be exactly the same as original PCB board, use the gerber file to reproduce the original PCB card;
1st of all, there is must be clear and reasonable orientation of the cloning electronic circuit card process, for example, input/output, alternative current and direct current, strong and weak signals, low frequency and high frequency, high voltage and low voltage, etc.
The orientation of circuit track pattern must be linear or separated, and there should be not intercourse with each other. The purpose of this arrangement of cloning Printed circuit board is to prevent the interference. And the best way of orientation of decoupling over printed circuit board reverse engineering, but normally it is not easy to realize, and the worst way is cycle, fortunately the isolation can be modified. As for the direct current, with small signals, low voltage Printed circuit board cloning, the expectation can be lower than normal standard. So the terms of reasonable is comparable.
2nd, choose a better connection point, there have been countless of technicians discussed such a small connection point through which we can understand its importance, generally need to share the common ground layer, for example, the ground line of forwarder amplifier must be connected with the ground layer after concentration, etc. as a matter of fact, it is quite difficult to achieve it due to various restriction in the process of electronic pcb card reverse engineering. but need to do the utmost to comply with the policy. This issue could be quite flexible in the practical usage. Each engineer who in response for Cloning PCB card must have their solution of their own, which will be easier to make the explanation according to the physical Printed circuit board.
Tags: cloning pcba,cloning printed circuit board,cloning printed wiring board,cloning pwb,cloning pwba