Clone Electronic PCB Board Gerber File

When Clone Electronic PCB Board Gerber File, the PCB board layout diagram can’t be traced at an acute angle. Regardless of whether the trace at an acute angle will have a negative impact on the high-speed signal transmission line, from the aspect of PCB DFM alone, it is necessary to avoid the situation of sharp-angled wiring.

Because at the point where the PCB wires intersect to form an acute angle, it will cause a problem called “acid traps”,

In the PCB manufacturing process, in the etching process of the PCB circuit board, the “acid traps” will cause excessive corrosion of the PCB circuit and cause the problem of virtual disconnection of the PCB circuit.

Although, we can use CAM 350 to perform DFF Audit to automatically detect potential problems of “acid traps” to avoid processing bottlenecks during PCB manufacturing. If the PCB factory technicians detect the existence of acid traps, they will Simply paste a piece of copper into this gap.

Many engineers in PCB board factories do not actually understand circuit board layout. They only repaired the acid trap from the perspective of PCB reverse engineering and processing, but whether this repair will bring about further signal integrity problems. It’s not known, so we should try to avoid acid traps from the source when Clone Electronic PCB Board Gerber File.