Overlay from Clone PCB Assembly Board

When clone Pcb assembly board, in order to facilitate pcb assembly, symbol mark and legendary will be required to print on the top and bottom side of the printed circuit board, such as the component marks and declared value, component profile, manufacturer logo and production date, etc.

when quite a few of the learners design the markings, they only focus on the order and appearance of the markings, while ignore the real effect of the marking after being made, since these marks is either being block or invade into the soldering area which will bring troubles for Pcb assembly board clone.

some of the markings have been even printed on other components, in the correct way of design markings after clone must follow below rules: without any errors and mismatchment, use the proper place for marking and make it order with good appearance.

Circuit Engineering Co.,Ltd. is a leading provider of PCB reverse engineering and manufacturing services incorporating design, PCB assembly, box build, global supply chain management and integrated technologies.

With specialist knowledge of integrated design and manufacturing solutions for high technology, high mix and complex products, we offer a complete service, design (electronic, mechanical and software), prototype, new product introduction (NPI), global procurement, in house tooling and moulding, PCB assembly, box build and test, packaging and global logistics.

Our design and engineering expertise – from product design based on customer concept through to re-engineering of existing assemblies – provides comprehensive design support throughout your product life cycle.

With a choice of manufacturing location to suit your volume and technology requirements, we provide global procurement and cost effective sourcing through wholly owned facilities in the Asia.

As a strategic design and manufacturing partner, we provide a complete end-to-end managed solution delivering your product on time and on budget when clone pcb assembly board.