Layout Quality Control of PCB Board Copying

The quality priority installation must be higher than the quantity priority set up by automatic layout algorithm which is always follow the designer’s intention. If the quality issue does exist, make the connection failure is better than make a low quality layout from PCB Board Copying, and the way will be very correct, and there are two reasons, the designer’s intension has been fully executed and let the engineers to decide the connection quality.

However, only when the failure tracks’ connection is relatively simple and partially taking effect, these opinions will be workable. As we all know, the layout tool can’t 100% fulfill the planned layout structure is a very typical patterns, at this moment it is not possible to sacrifice the quality to allow the plan failure as a result of that leave those unconnected wires.

All of the wires can be layout through the topology plan after PCB Board copying, but not all of them can lead to component leads. This can ensure the failure connection save some spaces and provide a relatively stable and easy to connect wires.

Topology plan can cooperate with the digital signal process, designer can use these tools effortlessly, but it will be only relate to the certain space, layer and connection flow functions with complex plan. Engineer can use topology tools from the preliminary stage, and after the intellectual property has been obtained from them, and it depends on the target of the flexible tools they are applying, to better adapt to the environment.

Topology layout tool can only simply follow the designer’s plan or intension to improve the high quality layout result, when facing the ECO, TOPOLOGY plan can be much faster and easier to be operated and connected, as a result of that, the topology tool can be accepted and applied on ECO easier and faster to provide a better and more precise results.