Electronic PCB Card Duplicating Schematic

Electronic PCB Card Duplicating Schematic can help engineer to restore the layout diagram, gerber file and BOM list from exisiting electronic pcb card, and make necessary improvement through duplicated schematic diagram;

In the general drawing of Electronic pcb card must present the interconnecting details on each component, and all of the component arrangement when reverse engineering Electronic pcb cards in the system must be depicted, and nowadays most of the schematic drawing from Electronic pcb card duplicating are prepared by the computer aided design software. Below we will use the CIRCUITMAKER TM to present the example:

In order to ensure the smooth and normal operation on the schematic diagram from printed circuit board duplicating, simulation by the computer software is necessary. This kind of software can be used to read the design drawing, furthermore, use multiple ways to reveal the circuit operation situation. Which has a much higher efficiency then produce a physical Electronic circuit board and then run the manual test on it.

Placement of Electronic pcb card component

The method of component placement on the PCB circuit board reverse engineering, it is determined by their interconnected method. And these components must be connected in the most efficient way. The so call most efficient layout method is the shorter wire and less layer count on the Electronic pcb card, at the same time, the good side effect of less layer count is the miniature of through hole quantity, however, in the real case of Electronic printed circuit board layout optimization, this question will be raised again.

Tags: pcb assemble duplicating,pcb board duplicating,pcb card duplicating,pcb duplicating,pcba duplicating,printed circuit board duplicating,printed wiring board duplicating,pwb duplicating,pwba duplicating